my cz20.........

ok....i have not called fisher yet but i would like to have the seals/o-rings replaced, they look a little dry and cracked. have any of you done this without sending the unit to fisher and if you have let me know how and what to use.
 i have heard that for fisher to do this they would have to replace the front panel with a new cz21 panel and i would rather not do that.

The last I heard Fisher was not repairing the CZ20, but they might be doing that now.  I would not attempt this yourself.  When my CZ20 goes I might not replace it with the 21.

Once you go into that replace the front panel business it's going to cost almost as much as the machine is worth used.  Good luck!

Not only is it going to cost a lot to do that (if it isn't under the original warranty) but it takes them FOREVER to get it done!  They had mine for over 2 months before I got it back and when I did it still didn't work and I had to send it in again!  Good luck

well i sent an e-mail to fisher service....i have never had a bad experience with them!!!!
i remember your ordeal mumszie.....i think you ticked them off